BT13 Series 18 gauge brown Brad nails for use with the Bostitch brad nailer. Finish nails (Brads) are normally of a rectangular cross section instead of being round. Their diameters are less than the coil and stick nails, and are primarily used for finish and trim work in the construction and joinery industries.Length : 40mmColour : Brown.Pack : Clam pack of 1000.
This Einhell Power X-Charger is a fast charger, suitable for all Power X-Change batteries. It can be fastened onto a wall and features a charging condition display. Specification Charging Time: 5.2Ah: 130mins, 3.0Ah: 60mins, 1.5Ah: 30mins.Weight: 0.4kg.
The Makita HP2071F Percussion Drill is fitted with a high power motor but packed into a slender and compact body with durable metal gear housing (with a keyless chuck). The new reversing system allows extended service life of carbon brush and no power reduction even in reverse rotation. It is fitted with a torque limiter, the drill stops when the bit hits against reinforcements. It is supplied with a side handle, depth stop and a carry case. Specification: Input Power: 1,010W No Load Speed: 0-1,200/0-2,900/min Impact Rate: 0-24,000/0-58,000/bpm Capacity: Steel 18mm, Masonry 20mm, Wood 40mm Weight: 2.4kg Vibration Hammer Drilling : 16 m/sec² Vibration K Factor : 1.5 m/sec² Noise Sound Pressure : 99 dB(A) Noise Sound Power : 110 dB(A) Noise K Factor : 3 dB(A)
Stabila Spirit Level 2 Vial, is a smooth-ribbed box section spirit level, the ribbed profile provides extra strength preventing the profile from bending. This spirit level can be used to check the horizontally of overhead surfaces by turning it and its horizontal vial upside down. You can then measure precisely from underneath.1 vertical vial and 1 horizontal vial. Measurement accuracy: in the normal position 0.029° = 0.5 mm/m. For overhead measurements: 0.043° = 0.75 mm/m. Stabila patent. Vials that are moulded in.Stabila 80AN Level 2 Vial.Length: 1000mm (40 in).
These Lindstrom Diagonal cutting nippers have an oval head. They are produced from high performance ball bearing steel which is black oxidised for increased durability. The numerically controlled machine grinding guarantees edge and angle accuracy and contact, which increases tool reliability and consistency. The edges are precision induction hardened to 63-65 HRC. The handles have a return spring and are sleeved. Ideal for wire harness work, and standard printed circuit board assembly. Oval heads are the most common type of nipper head. It combines strength and durability, can withstand and distribute the impact of cutting and is utilised in a myriad of applications.Length (A): 125mm (5 in). Blade length (B): 16mm (0.63 in). Head width (C): 16mm (0.63 in). Head depth (D): 8mm (0.31 in). Tip width: (F): 1.6mm (0.06 in). Cutting capacity: 0.4-2.0mm. Cutting edge: Micro-bevel. The Micro-Bevel cut is designed to meet the requirements of the electronic assembly industry. Leads are ‘pinched’, allowing less altitude and a smaller overall surface area. Because of its design, it has a wide cutting range and variety of uses.
