Abus T65AL/40 Blue Aluminium Padlock 50008

Interchangeable heads for Pipemasters irons.1 x Antex 22mm Heads Only for Pipemaster V00225

Featuring 24 torque settings this 18 Volt compact drill driver is also designed with a two speed gear box.The soft grip overmould design on this Ryobi RCD180M provides both reduced vibration and an enhanced grip.

IRWIN Record replacement end cut jaws suitable for 924E/BC924E bolt cutters.

This Faithfull rule is extruded from 50 mm wide anodised aluminium, and is clearly graduated on both edges.It also features a handy metric / imperial conversion chart on the reverse and a hanging hole for storage.Imperial and Metric markings.Length: 1m (39 in)

Multi-purpose combination square for use in both wood and metalworking applications. Each square features a high quality cast and machined sliding stock, fitted with a stainless steel rule engraved with both imperial and metric graduations, a spirit level and marking scribe.The Faithfull combination square has at least 10 different uses including:-Measuring rule with metric and imperial scale, 90° inside square, 90° outside square, 135° inside square, 45° inside square, horizontal level, vertical level, T-square slide, marking gauge and depth gauge.Ruler Length : 400 mm / 16 inch.

The Lindstrom Supreme Oblique Cutting Nipper produced from high performance tool steel. It has a screw joint that minimises friction and alignment of cutting edges. The edges are precision induction hardened to 58-60 HRC. The handles with return spring and sleeved.Length (A): 108mm (4.25 in).Blade length (B): 8mm (0.31 in). Head width (C): 10.5mm (0.41 in). Head depth (G): 15mm (0.59 in). Cutting capacity: 0.35-1.25mm. Head type: Double angled. Cutting edge: Flush. Angled heads, also known as oblique style, are set at an angle to the main body of the cutter. This means that the cutter can reach between parts and areas which are difficult to access. The Flush Bevel cut is designed to meet the requirements of the electronic assembly industry. Leads are ‘pinched’, allowing less altitude and a smaller overall surface area – more than Micro-bevel cuts. The cutters have fine cutting edges that leave a narrow and short taper and small exposed area. They can be used to meet tight specifications for a flush result to a board, component or part.