Faithfull Nail punch with a square head which provides a larger striking area and stops the punch rolling off the bench. Accurately hardened and tempered with a precision formed concave tip for better nail contact. Designed to drive nail heads below the surface of the wood.Point Diameter: 4.0mm (5/32in)Length: 100mm (4in)
The Faithfull FAIPLANE912 is a 9.1/2 Block plane seated at 21º with a 42mm cutter width. The planes are designed for end grain work or in any situation where a single handed operation is required. The low angle cutter and fully adjustable mouth from wide for coarse work to narrow for the fine shaving of awkward grain, make these planes ideal for all types of end grain work. Presented in a hinged wooden box. Cutter Width: 42mm.Overall Length: 160mm.
The Knipex 26 21 200 bent long nose side cutters have long flat round jaws that are highly loadable, with elastic precision points with blades for hard wire diameter up to 2.2mm and medium wire diameter up to 3.2 mm. The cutting edges are separately induction hardened for durabilty and longer working life and are hardend to approximately 61HRC. The jaws are angled at 40° and are ideal for use on electronic or tight to reach areas on computers, circuitry, or motor vehicles applications. Knipex have used a good quality special tool steel material that is oil hardened. Dipped handles.The Knipex 26 22 200 bent long nose side cutters have Bi-material, 2-component handles for a more comfortable and positive grip. They have long flat round jaws that are highly loadable, with elastic precision points with blades for hard wire diameter up to 2.2mm and medium wire diameter up to 3.2 mm. The cutting edges are separately induction hardened for durabilty and longer working life and are hardend to approximately 61HRC. The jaws are angled at 40° and are ideal for use on electronic or tight to reach areas on computers, circuitry, or motor vehicles applications. Knipex have used a good quality special tool steel material that is oil hardened. Hard wire diameter: 2.2 mm.Medium wire diameter: 3.2 mm.Hardness approx. 61HRC.Length. 200 mm.
The ABUS 65 Series brass padlocks have a body which is made from solid brass, hardened steel shackle up to 30mm and hardened steel alloy shackle 40mm and above. The inner components are made from non-corrosive materials. The precision pin cylinder has mushroom counter pins with the paracentric key-way offering greater protection against manipulation. They are suitable for low to medium security requirements and are also suitable where a strong requirement for service performance and longevity is required. The padlock locking is automatic, it does not require a key.The cylinder can be re-keyed to match an existing key (Keyed Alike). Overall width: 30 mmOverall height: 50 mmOverall depth: 14 mm Shackle width: 16 mm I.D.Shackle height: 17.5 mmShackle Dia: 5 mm
