BT13 Series 18 gauge brown Brad nails for use with the Bostitch brad nailer. Finish nails (Brads) are normally of a rectangular cross section instead of being round. Their diameters are less than the coil and stick nails, and are primarily used for finish and trim work in the construction and joinery industries.Length : 40mmColour : Brown.Pack : Clam pack of 1000.
The DEWALT DCK206M2 Twin Pack, contains the following: 1 x 18 Volt DCH253 3 Mode SDS Hammer Drill that is ideal for drilling anchors and fixing holes into concrete, brick and masonry from 4mm to 24mm. The hammer drill has a rotation stop mode for light chiselling in plaster, tiles and render and an impact stop mode for rotary only drilling in wood and metal. It uses 4.0Ah 18 Volt Lithium Ion batteries to deliver high performance, long life and maximum runtime. No Load Speed: 0-1,200/min.Impact Rate: 0-4,500/min with 2.1 Joules.Capacity: Concrete: 24mm, Steel: 13mm, Wood: 26mm.Weight 3.1kg. 1 x 18 Volt DCD785 XR Compact Hammer Drill Driver has an ultra compact, lightweight design that allows it to be used in confined spaces, whilst the intelligent trigger design allows for total control of application. It has a two speed, all metal transmission for increased run time and a longer tool life. Chuck: 13mm Keyless.No Load Speed: 0-600/0-2,000/min.Impact Rate: 0-10,200/0-34,000/bpmTorque: 60Nm, 14 Settings.Capacity: Steel: 13mm, Masonry: 13mm, Wood: 38mm 1 x 10.8-18 Volt DCB105 Multi-Voltage XR Charger varies the charge rate according to battery type to increase battery pack life. It features diagnostics with bright LEDindicator which communicates the battery charge status: charged, charging, power problem, and battery too hot or too cold. Charges all XR Li-Ion DEWALT Slide Pack 10.8, 14.4, and 18 Volt batteries.
Disston Screwdiggers fulfil the same function as Screwsinks but the countersinking part can be slid up and down the drill part of the tool.Ideal for drilling, countersinking and counterboring in one operation.This means that a No.8 Screwdigger can be adjusted to predrill for different lengths of No. 8 Screw.Uses 7/64in Drill Bit.To ensure an acurate fit we suggest you use the same Plug Cutter from the Disston brand.For No 8 screw
Masajeador muscular eléctrico de 12 V Percusión portátil Vibrante Pistolas de masaje potentes Masajeador muscular de tejido profundo de mano para cuello Espalda Hombros Pie pierna
The Carver T186-600 Standard-Duty Bar utilises the same jaws as its rack clamp equivalents. It can be used either for clamping or jacking apart. Size: 60cm (24in).
These 23 gauge mini pins are headless fine wire pins that are indispensible for fine molding and trim work. As the pins are completely headless , the wood closes over them after driving eliminating the need for time consuming fillingThey are also excellent for temporary tacking whilst glue dries, as they can be removed with little damage to the work.For use with the Bostitch headless pinner.Length 12 SKU 1061200SE Finish STANOX (Copperwash)Description Mini Pin 12mm Stanox 20m Qty per box 20000 Suits: TU216-2330 Tacker
