The Yale Easy Fit Pet Friendly PIR Motion Detectors are suitable for connection with and to extend the Easy Fit alarm systems. They are ideally placed in the corner of any room that needs protection, such as a lounge, bedroom or extension. They are also suitable for garages and outbuildings. When the alarm is set, the infrared sensor will pick up movement and activate the siren. These motion detectors are suitable for households with pets, as they will not be triggered by a pet that weighs below 27kg. However, they are not suitable for multiple pets.This pack contains the following: 1 x PIR motion detector.4 x Wall plugs and screws.3 x 1.5V AAA alkaline cells (pre-fitted).
Few things are more dispiriting than turning the ignition key and hearing nothing. Just when you need your car to start, it plays dead. Worse still, it's probably your fault. Look at the lights switch - did you leave them on? Modern car batteries are very reliable, but leaving the lights on for a few hours will soon discharge them. Even a boot light or an interior light left on overnight can flatten a battery. And a car left standing for a month or so may discharge its battery just from the current drawn by the alarm.To start a car with a flat battery you need the S Style SSJL200, a set of good quality heavy-duty cables with beefy clamps at each end, and a friend is also a good help! Your friend must have a car with a battery in good condition, this will aid in the success on starting your flat battery. Simply position another car near yours so that the batteries are close, but do not let the vehicles touch. Connect one end of the SSJL200 red jump lead to the positive (+) terminal of the boosting battery (Do not let the other end of the red lead touch any vehicle metal components) and connect the other end of the red lead to the positive (+) terminal of the flat battery. Then connect one end of the SSJL200 black jump lead to the negative (-) terminal of the boosting battery and connect the other end of the black lead to a bolt or metal bracket, well away from the battery, on the engine block of the vehicle to be started is a good source. Ensure that the S Style SSJL200 jump leads cannot come into contact with any moving parts of either engine. Start the engine of the boosting vehicle and run it at a fast idle speed for a few minuets. Now turn the ignition to start the engine of your vehicle, the S Style SSJL200 will pull power from the boosting battery to help your battery back to life. Check that your vehicle is running properly then carefully disconnect the SSJL200 and your on your way. 200 Amp.2.5m length.Jump lead with 10mm insulation.Supplied in poly bag with euro slot.
Artisanat:Imprimé; Composition:2 pièces (1 housse de couette, 1 housse d'oreiller),3 pièces (1 housse de couette, 2 housses d'oreiller); Style:Crâne; Matière:Polyester; Type de fermoir:Fermeture; Type d'article:Ensembles housse de couette; Motif:Blagues,Crânes; Date de l'annonce:01/13/2023; SizeChart1_ID:128:183014; Taille de la housse de couette:; Taille de la taie d'oreiller:; Source de données du guide des tailles:Fourni par le fournisseur.; Type d'impression:3D effet
The Yale M999 rebated tubular mortice latches are suitable for rebated french doors or internal doors where no locking is required. The latch bolt is withdrawn by spring lever handle from either side but they are not suitable for unsprung lever handles. Polished brass finish.Length: 64mm (2 1/2 in)
