Pin vices are chiefly used for holding small taps, reamers, scribers or wire. The handles are tubular which permit holding wires of any length or diameter up through the length of the tool.Size: 1Capacity: 0 - 1mm (0 - 3/64 in)
This Facom 2-piece Quatro wrench set consists of 2 wrenches offering 8 different sizes. Each size wrench has a 5° ratchet mechanism. With 4 different sizes per wrench, these wrenches are space-efficient and easy to store. Combined, these two wrenches provide the most common sizes, and therefore are ideal for tightening/loosening most nuts and bolts. The smaller wrench has the following sizes: 8mm, 10mm, 12mm, and 13mm.The larger wrench has the following sizes: 16mm, 17mm, 18mm and 19 mm.
These Forgefix flat Bellwire Clips have hardened masonry nails for increased efficiency, and which will fix into timber, blockwork and mortar. The nail should not be hammered directly in brick, and fixing into mortar is recommended. Application:For fitting bell wire cable to timber or masonry in audio, visual and both commercial and domestic cabling.Cable Clip Flat White 1.50mm Box 100
The Lindstrom Supreme Oblique Cutting Nipper produced from high performance tool steel. It has a screw joint that minimises friction and alignment of cutting edges. The edges are precision induction hardened to 58-60 HRC. The handles with return spring and sleeved.Length (A): 108mm (4.25 in).Blade length (B): 8mm (0.31 in). Head width (C): 10.5mm (0.41 in). Head depth (G): 15mm (0.59 in). Cutting capacity: 0.35-1.25mm. Head type: Double angled. Cutting edge: Flush. Angled heads, also known as oblique style, are set at an angle to the main body of the cutter. This means that the cutter can reach between parts and areas which are difficult to access. The Flush Bevel cut is designed to meet the requirements of the electronic assembly industry. Leads are ‘pinched’, allowing less altitude and a smaller overall surface area – more than Micro-bevel cuts. The cutters have fine cutting edges that leave a narrow and short taper and small exposed area. They can be used to meet tight specifications for a flush result to a board, component or part.
