The Zenith Satin Mop is suitable for satin finishing work. It gives a satin or brushed finish to all metals.The ZENSFM62W Satin Mop has the following specifications:Grade: Medium.Size: 6 x 2in.
The Bulldog Premier Dutch Hoe has a carbon steel, angled blade with has a sharpened cutting edge and a powder coated finish. The handle is made from Ash. Head width: 126mm (5in).Handle length: 137cm (54in).
The ABUS 41 Series laminated steel padlocks are made up from individually plated laminated steel sections with the bottom most plate hardened. The laminates individually refined with the new 'Etrena' treatment process for optimum protection from corrosion offering up to 40 years weather protection. The rivets in the outer laminates are compressed to protect against the rivet heads being knocked off. Precision pin tumbler cylinder protected against drilling and leverage. Where to use it: Medium security requirementThe cylinder can be re-keyed to match an existing key (Keyed Alike). Overall width: 44 mmOverall height: 60 mmOverall depth: 26 mm Shackle width: 18.5 mm I.D.Shackle height: 20 mmShackle Dia: 7 mm
The Lindstrom Supreme Oblique Cutting Nipper produced from high performance tool steel. It has a screw joint that minimises friction and alignment of cutting edges. The edges are precision induction hardened to 58-60 HRC. The handles with return spring and sleeved.Length (A): 108mm (4.25 in).Blade length (B): 8mm (0.31 in). Head width (C): 10.5mm (0.41 in). Head depth (G): 15mm (0.59 in). Cutting capacity: 0.35-1.25mm. Head type: Double angled. Cutting edge: Flush. Angled heads, also known as oblique style, are set at an angle to the main body of the cutter. This means that the cutter can reach between parts and areas which are difficult to access. The Flush Bevel cut is designed to meet the requirements of the electronic assembly industry. Leads are ‘pinched’, allowing less altitude and a smaller overall surface area – more than Micro-bevel cuts. The cutters have fine cutting edges that leave a narrow and short taper and small exposed area. They can be used to meet tight specifications for a flush result to a board, component or part.